Harting Crimping Tool - Basic Tool 09 99 000 0620 (1)

Harting Crimping Tool-Basic Tool 09 99 000 0620

The basic tool
09 99 000 0620
Instruction Manual (1)


It can be used with the following crimping insert sets

Marking of the FC-contacts is stamped on their rear site.
Locators are supplied with the crimping sets.
To order them separately use the following part-no.

Set up Crimping inserts

Set up Crimping inserts
• Screw-off the fixing screw (1) – pliers closed
• Close tool until it releases (open now the tool)
• Remove inserts (first upper part)
• Install new inserts – marking (2) has to have same colour
– first insert lower part
• Fix the screws again with: ISKA M4x18 (upper)
ISKA M4x9 (lower)
• Plug the locator from the top in a 90° position as shown in the picture



Harting - Top Industrial Connectors Electronic Connectors Manufacturer in German