09 99 000 0620
Instruction Manual (2)
Safety ratchet
• The hand crimp tool can only be used after it has been
opened completely. Each crimp process has to be done fully, before the tool can be opened again. This guaranties a good quality crimp
each time.
Do not open or close the tool by force!
Early crimp unclamp
It is possible to open the tool during crimping if
necessary:
• Slightly hold together the grips of the tool
• Open the safety barrier on the rear side of the
tool by turning left or right
• Open the grips of the tool to release the partially
crimped contact.
Crimp process
• Fold up locator
• Assemble the contact into the locator 1 –
select the right chamber!
• Fold back the locator
• Close the tool until the contact will be hold– 2
• Put the wire into the crimp opening
• Crimp the contact until the tool can be released
• Take out the crimped contact.
Maintenance
Remove any existing material and dirt and clean the
crimp zone regularly. Check the crimp zone of the
tool for correct closing, clean all moving parts.
These should move smoothly in operation and lubricate them. (Use: machine oil
SAE 20).
Harting - Top Industrial Connectors Electronic Connectors Manufacturer in German
0 comments:
Post a Comment