Han® Q 8/0 Quick Lock Technical characteristics

Features

• Innovative Han-Quick Lock® termination technology
• Field assembly without special tools
• Compatible with Han® Q 8/0 standard inserts with crimp terminal
• Reduced wiring times
• Insert suitable for plastic hoods and housings of the sizes Han-Compact®
• Space-saving and compact design
• Leading protective ground contact

Technical characteristics

Specifications		DIN EN 60 644-1 DIN EN 61 984
Inserts
Number of contacts		8 + PE
Electrical data acc. to DIN EN 61 984		16 A 500 V 6 kV 3
	Rated current	16 A
	Rated voltage	500 V
	Rated impulse voltage	6 kV
	Pollution degree	3
Termination		Han-Quick Lock®
Insulation resistance		> 1010 Ω
Material insert		Polycarbonate
Material seal		NBR
Limiting temperatures		-40 °C ... +125 °C
Flammability acc. to UL 94		V 0
Mechanical working life		> 500 mating cycles
Contacts
Material		Copper alloy
Surface
- hard silver plated		3 μm Ag
Contact resistance		< 3 mΩ
Han-Quick Lock®
- mm²		0.5 – 2.5 mm²
- AWG		20 – 14
Maximum insilation cross section		ø = 3.6 mm
Plastic hoods/ housings
Material		Polycarbonate
Locking element		Polyamide
Flammability acc. to UL 94		V 0
Hoods/ housings seal		NBR
Limiting temperatures		-40 °C ... +125 °C
Degree of protection acc. to DIN EN 60 529 in locked position		IP 65

Current carrying capacity

The current carrying capacity is limited by maximum temperature of materials for insert and contacts including terminals. The current capacity-curve is valid for continuous, not interrupted current-loaded contacts of connectors when simultaneous power on all contacts is given, without exceeding the maximum temperature.
Control and test procedures according to DIN IEC 60512-5.
(1) Wire gauge: 0.5 mm²
(2)  Wire gauge: 1.5 mm²
(3)  Wire gauge: 2.5 mm²

Assembly Manual

Remove cable jacket and strip the fine stranded wires


Push fine stranded wires into the Han-Quick Lock® contact and push the blue slide with a screw driver1) until it comes to a stop

Removal Manual

Please insert the screw driver1) at an angle of 45° into the opening and lever the blue slide out

1) Screw driver: 0.4 x 2.5 mm or 0.5 x 3.0 mm


Harting - Top Industrial Connectors Electronic Connectors Manufacturer in German